In our previous study [Chien, I.L., Zeng, K.L., Chao, H.Y, Liu, J.H. (2004). Design and control of acetic acid dehydration system via heterogeneous azeotropic distillation. Chemical Engineering Science 59(21), 4547-4567.], an acetic acid dehydration system has been designed. The suitable entrainer selected for that system is iso-butyl acetate. Design and control of the system has been studied in detail to maintain high-purity bottom acetic acid concentration and also keep a small acetic acid loss through top aqueous draw. In that previous study, the feed composition is assumed to contain equal molar of acetic acid and water. However, in a typical waste acid recovery application, the above assumption may be too rich in acetic acid. In this paper, a feed stream containing 80mol% water and 20mol% of acetic acid is investigated. Several design alternatives can be deduced including one commonly used in industry by adding a pre-concentrator column in the upstream of a heterogeneous azeotropic distillation column. The necessity of this pre-concentrator column from design and control view points will be thoroughly investigated in this paper. The final recommended process design is a tradeoff between total annual cost (TAC) and operability of the system. The recommended design is a single heterogeneous azeotropic distillation column with aqueous reflux stream. Very wide feed composition and flow rate changes can be handled by this design with proper choice of the overall control strategy. (c) 2005 Elsevier Ltd. All rights reserved.