Photocatalytic oxidation of propylene with molecular oxygen at room temperature was investigated over various silica-supported metal oxides with low loading. The photocatalytic active site is assumed to be the isolated tetrahedrally coordinated metal oxides in the ligand-to-metal charge-transferred state, such as (Mdelta--O-L(delta+))*. Photocatalytic epoxidation of propylene into propylene oxide was promoted over silica-supported V and Ti oxides at steady state. Over silica-supported Cr oxide, the propylene oxide formation rate was remarkably decreased with the time course in the reaction. The oxidation state and the coordination environment of the supported Ti, V, and Cr oxide species were determined by diffuse reflectance UV-vis spectroscopy (DRS) and electron spin resonance (ESR). During the photocatalytic oxidation, the oxidation state of the Ti4+ species was not varied. On the other hand, the V5+ species was partially reduced to V4+ and the Cr6+ species was successively reduced to Cr5+ and Cr3+. An isotopic tracer study of the C3H6-O-18(2) reaction suggests the difference of the active oxygen species between TiO2/SiO2 and V2O5/SiO2. The active oxygen species on TiO2/SiO2 is derived from molecular oxygen. On the other hand, the photogenerated products on V2O5/SiO2 incorporate the lattice oxygen of the surface metal oxide species. It is suggested that the kinds of terminal ligand (hydroxyl or oxo) of the tetrahedrally coordinated metal oxides on silica decide the active oxygen species in the photocatalytic oxidation. A photoinduced hole center on the monohydroxyl (SiO)(3)Ti-OH species activates molecular oxygen that reacts with propylene. In the case of the monooxo (SiO)(3)V=O and dioxo (SiO)(2)Cr=O-2 species, the photoactivated lattice oxygen (O-L(-))* directly reacts with propylene.