This paper describes the testing of the gas-diffusion electrodes for polymer electrolyte membrane fuel cells utilizing phosphoric acid doped polybenzimidazole (PBI) electrolyte, which allows for an operating temperature as high as 200 degrees C. In order to determine the optimum structure of our anodes and cathodes, the platinum content in the Pt/C catalyst and catalyst loading were varied, as well as the loading of the PBI electrolyte dispersed in the catalyst layer. The different MEAs were tested in terms of their performance by recording polarization curves using pure oxygen and hydrogen. It was found that a high platinum content and a thin catalyst layer on both anode and cathode, gave the overall best performance. This was attributed to the different catalyst surface areas, the location of the catalyst in relation to the electrolyte membrane and particularly the amount of PBI dispersed in the catalyst layer. Scanning electron microscopy (SEM) was used in order to examine the cross-section of the MEAs and measure the thickness of the catalyst layers. With this information, it was possible to give an estimate of the porosity of the catalyst layer. (c) 2006 Elsevier B. V All rights reserved.