Adsorption of a cationic polyelectrolyte, polyallylamine hydrochloride (PAH), having a molecular weight of 70,000 on mica was characterized by the streaming potential method and by deposition of negative polystyrene latex particles. Formation of PAH layers was followed by determining the apparent zeta potential of surface as function of bulk PAH concentration. The zeta potential was calculated from the streaming potential measured in the parallel-plate channel formed by two mica plates precovered by the polyelectrolyte. The experimental data were expressed as the dependence of the reduced zeta potential xi/xi(0) on the PAH coverage Theta(PAH), calculated using the convective diffusion theory. It was found that for the ionic strength of 10(-2) M, the dependence of xi/xi(0) on Theta(PAH) can be reflected by the theoretical model formulated previously for surfaces covered by colloid particles. The electrokinetic measurements were complemented by particle deposition experiments on PAH-covered mica surfaces. A direct correlation between the polymer coverage and the initial deposition rate of particles, as well as the jamming coverage, was found. For Theta(PAH) > 0.3 the initial deposition rate attained the value predicted from the convective diffusion theory for homogeneous surfaces. The initial deposition rates for surfaces modified by PAH were compared with previous experimental and theoretical results obtained for heterogeneous surfaces formed by preadsorption of colloid particles. It was revealed that negative latex deposition occurred at surfaces exhibiting negative apparent zeta potential, which explained the anomalous deposition of particles observed in previous works. It was suggested that the combined electrokinetic and particle deposition methods can be used for detecting adsorbed polyelectrolytes at surfaces for coverage range of a percent. This enables one to measure bulk polyelectrolyte concentrations at the level of 0.05 ppm. (c) 2006 Elsevier Inc. All rights reserved.