By heating the admixture of a commercial liquid electrolyte (LB302, 1 M solution of LiPF6 in 1:1 EC/DEC), methyl methacrylate (MMA) and benzoyl peroxide (BPO, initiator), a poly(methyl methacrylate) (PMMA) based gel-polymer electrolyte (GPE) was obtained. AC impedance spectroscopy and cyclic voltammetry were used to evaluate its ionic conductivity and electrochemical stability window. Rechargeable cells LiNi0.8Co0.2O2/Li and LiNi0.8Co0.2O2/graphite with this MMA based GPE were also fabricated via the in-situ thermal polymerization process. This GPE exhibits a high ionic conductivity (over 10(-3)S cm(-1)) at room temperature. It is stable in the voltage range between 0 and 4.2 V (vs. Li+/Li). A phenomenon of large initial cell impedance (LICI) was observed for the LiNi0.8Co0.2O2/Li cells but not in LiNi0.8Co0.2O2/graphite cells. After the first several cycles, the cell impedance decreases substantially and reversible charge-discharge capacity can be obtained. This in-situ polymerization method provides a way to produce GPE cells.