화학공학소재연구정보센터
Electrochimica Acta, Vol.52, No.4, 1523-1526, 2006
Rapidly solidified Ti-Si alloys/carbon composites as anode for Li-ion batteries
Ti-Si alloys with the nominal composition of Ti14S86, Ti16Si84, Ti21Si79 were rapidly solidified using a single roller melt spinning technique. The melt-spun Ti-Si ribbon powders were mechanically milled with graphite powders, followed by the carbon coating through pyrolysis of coal tar pitch at 900 degrees C under argon flow. These composite electrodes exhibit good cycle performance, especially when the Si content in the Ti-Si alloy is below the composition of the Si+TiSi2 eutectic. (c) 2006 Elsevier Ltd. All rights reserved.