Silicotungstic acid incorporated sodium alginate (STA-NaAlg) hybrid composite membranes were prepared by incorporating 1, 2, 3 and 5 wt.% of silicotungstic acid (STA) into sodium alginate (NaAlg) and crosslinked with glutaraldehyde. Scanning electron microscopy and universal testing machine were used to investigate the morphology and the mechanical strength properties of the membranes. These membranes were tested for pervaporation (PV) dehydration of acetic acid at lower water concentrations of 10-25 wt.% in the feed. Addition of STA into NaAlg could result in a dramatic increase of water selectivity over that of plain NaAlg membrane dehydrating acetic acid for lowest STA containing NaAlg membrane. Thus, infinite selectivity was observed for STA-NaAlg membrane containing 1 wt.% of STA for all feed mixture compositions ranging from 10 to 25 wt.% water. With increasing STA content from 2, 3 and 5 wt.% in NaAlg membranes, selectivities ranged from 22,491 to 288, 12,848 to 192 and 6914 to 108, respectively for the studied composition range of the feed mixtures. PV performances of STA-NaAlg hybrid composite membranes were also tested at 40, 50, 60 and 70 degrees C typically in case of 10wt.% water-containing feed mixture, which indicated a decrease in selectivity and increase in flux for all hybrid composite membranes. Arrhenius plots of flux data versus reciprocal of temperature exhibited linear trends. The hydrophilic STA is responsible to offer increased selectivity and flux to water as compared to plain NaAlg membrane for the feed mixtures studied. Of all the membranes tested, the 1 wt.% STA containing NaAlg membrane exhibited the best PV performance characteristics. Temperature did not influence much the selectivity data of STA-NaAlg membrane containing 1 wt.% of STA up to 50 degrees C, but flux increased with increasing temperature for all membranes. The results of this study are far superior to the previously reported data on acetic acid dehydration by the PV technique. Published by Elsevier B.V.