This work studies the effectiveness of a process proposed for the recovery of ethylenediaminetetraacetic acid (EDTA) and metal precipitation from soil flushing solutions. Two series of experimental tests were carried out on two samples of a soil artificially contaminated with copper or lead. The metals were extracted from the soil by flushing with a 0.05 M aqueous solution of EDTA sodium salt (E-Na-2). Cu or Pb extraction efficiencies of about 95 and 98% were observed, respectively. The two extracted solutions were then treated to obtain EDTA recovery and metal precipitation from the aqueous solution. EDTA recovery was achieved in two steps. An initial evaporation treatment lead to reduce the solution volume by about 75%. This was followed by the acidification of the residue solution, which precipitated more than 93% of the used EDTA. The precipitated EDTA was removed by filtration, and was suitable for reuse after adding an alkaline agent. Metal precipitation from the filtered solution was performed using two different methods: an almost total (99.5%) Pb precipitation in alkaline conditions was achieved after complex destabilization through the sequential addition of ferric ions and sodium phosphate, while 93.6% copper precipitation was achieved with ferrous sulfate as a destabilization agent. (C) 2003 Elsevier B.V. All rights reserved.