A way to convert the volume change of a biochemo-mechanical gel into the change in liquid column length was developed. Our trial sensor device consisted of a small compartment for incorporating the gel, a flow channel with a filled dye solution, and a poly(dimethylsiloxane) (PDMS) diaphragm by which the gel and the dye solution were separated. A lightly cross-linked N-isopropylacrylamide (NIPAAm)/acrylic acid (AA) copolymer gel with immobilized glucose oxidase was used as a sensing element. It was found that a change in the gel volume caused by the immobilized enzyme reaction was accurately converted into a change of the column length (Deltal) with the help of the PDMS diaphragm. By use of a cylindrical gel (diameter similar to2 and thickness similar to1 mm), the time curve of Deltal varied depending upon glucose concentration over a range of 0.2-50 mM; in particular, it is of importance that semilogarithmic plots of Deltal (in mm) against glucose concentration (in mM) can be used as a calibration curve. For glucose solutions of mM order, I min was enough to determine the concentrations, whereas 10 min was required for concentrations of muM order. When the measurement time was limited within 10 min, the lower detection limit was 200 muM. The response was affected by buffering capacity of the samples, but this was controllable through reduction of the sample volume. These results indicate that the present way can be used for the determination of glucose concentration.