Shear and extensional viscosities and wall slip are determined simultaneously under extrusion processing conditions using an on-line rheometer. Because it is not possible to independently control flow rate and temperature, classical methods for interpretation of capillary data cannot be used with on-line rheometry. This limitation is overcome using computational optimization to fit parameters in a flow model. This consists of three parts, representing shear viscosity, extensional viscosity, and wall slip. Three-parameter, power law forms, based on local instantaneous deformation rates and including temperature dependence, are used for each, and analytic solutions applied for entry flow and flow in the capillary. For entry flow, the Cogswell-Binding approach is used, and for developed flow in the capillary a solution incorporating wall slip is derived. The rheometer, with interchangeable capillaries, is mounted in place of the die on a rubber profile extrusion line. Pressure drops and temperatures for extrusion of an EPDM rubber through :2 mm diameter capillaries of length 0, 2, 3, 4, and 5 mm are logged and flow rates determined for a range of extruder speeds (5 to 20 rpm). Pressures ranged from 60 to 75 bar and temperatures from 86 to 116 degrees C. Mean flow velocity in the capillaries was between 5 x 10(-3) and 5 x 10(-1) m s(-1). The nine material parameters are optimized for best fit of the analytic pressure drops to experimental data, using about 100 data points, with the Levenberg-Marquardt method. It is concluded that flow is dominated by extension and wall slip. Shear flow appears to play little part. The slip model indicates that slip velocity increases much more rapidly than the wall shear stress (in the range 0.5-1 MPa) and decreases with temperature for a given stress level. Results for the (uniaxial) extensional viscosity represent an engineering approximation to this complex phenomenon at the high strains (approximately 200) and high extension rates (up to 800 s(-1)) applying in the extrusion. Results indicate a slight extension hardening and a decrease with temperature. Results are put into the context of the available studies in the literature, which, particularly with regard to wall-slip and extensional flow, consider conditions far removed from those applying in industrial extrusion. The present methods provide a powerful means for flow characterization under processing conditions, providing data suitable for use in computer simulations of extrusion and optimization of die design.