This article presents research findings for selected mechanical properties of polyurethane elastomers. The studied elastomers were synthesized with the prepolymer-based method with the use of controlled molecular weight distribution (MWD) urethane oligomers and with the classical single-stage method. Prepolymers with defined MWDs were obtained with the use of a multistage method, that is, step-by-step polyaddition. To produce elastomers, isocyanate oligomers were then crosslinked with triethanolamine, whereas hydroxyl oligomers were crosslinked with 4,4',4"-triphenylmethane triisocyanate (Desmodur RE). The tensile strength of the obtained elastomers ranged from 1.0 to 7.0 MPa, the ultimate elongation approached 1700%, the Shore A hardness varied from 40 to 93 degrees, and the abrasion resistance index fell within 15-140. The effects of the types of raw materials used, the chemical structures, the production methods, and the supermolecular structures on the mechanical properties of the obtained polyurethane elastomers were examined. When the obtained findings were generalized, it was concluded that the structural changes in the polyurethanes, which were favorable for intermolecular interactions, improved the tensile strength, hardness, and abrasion resistance of the materials and impaired their ultimate elongation at the same time. More orderly supermolecular structures and, therefore, superior mechanical properties were found for polyurethane elastomers produced with the prepolymer method. (c) 2007 Wiley Periodicals, Inc.