Metal matrix composites containing titanium nitrides or titanium borides raise great interest to researchers due to their high wear resistance and enhanced corrosion properties. In the present investigation composite coatings containing both titanium nitrides/carbonitrides and titanium diborides were produced on plain steel substrates using the plasma transferred arc ( PTA) technique with argon-nitrogen mixtures in the plasma and shielding gas. The microstructure of the metal matrix composites (MMC) obtained was thoroughly studied and found to consist of primary titanium diboride particles surrounded by a eutectic matrix containing, apart from ferrite, both titanium diboride and titanium carbonitride particles. The wear behavior of the composite coatings was assessed by pin on disk experiments. The wear rate against both a tool steel counterbody and an alumina counterbody is of the order of 10(-4) mm(3)/m. The friction coefficient for both the alloyed layer-tool steel system and the alloyed layer-alumina system increases up to sliding speed of 0.30 m/s and then decreases, when the sliding speed increases further. Specifically, the friction coefficients are varied between the values 0.5 and 0.65. The wear mechanism for the tribosystem alloyed layer-tool steel is characterized by plastic deformation and adherence of material coming from the alloyed layer to the surface of the ball, while for the tribosystem alloyed layer-alumina ball, severe plastic deformation and formation of oxide layer are observed. (C) 2008 Elsevier B.V. All rights reserved.