The objective of this study was to improve interfacial adhesion properties at the interface of thermomechanical pulp TMP) fiber and isotactic polypropylene (iPP) using thermoset adhesives such as phenol formaldehyde (PF) and urea formaldehyde (UF). This study also attempted to achieve fiber-to-fiber adhesion using thermoset adhesives before the molten iPP would flow into the fiber web. The fracture surfaces with thermoset adhesive showed identical differences in terms of fracture modes at the interface. An increased TMP fiber failure was observed with increased thermoset quantity at the interface. Using one percent resin content of weight fraction of TMP fiber handsheet, the tensile strength properties increased almost two fold higher than the strength of control samples. Additional adhesive contents of three and five percent showed gradual strength enhancement. However, the enhanced strength was statistically insignificant. UF resin showed slightly better strength performance over PF resin. This result may be caused by solid contents and additional pigments of resins.