Cobalt content, grain size, microhardness and tensile strength of nanocrystalline Ni-Co deposits produced from a solution containing saccharin and cobalt sulfate at constant electrodeposition conditions (pulse on-time T-on at 1 ms and pulse off-time T-off at 15 ms) but varying the peak current density J(p) were investigated. It is found that an increase in J(p) makes the deposit Co content lower, colony-like morphology more obvious, grain size smaller, and hardness and tensile strength higher. All of the facts are believed to result from the higher overpotential and nucleation rates caused by the J(p) increase. But its further increase could lead to reduction in the hardness and tensile strength. Peak current densities in the range of 100-120 A dm(2) are recommended for the preparation of nanostructured Ni-Co alloy deposits with grain sizes in the range of 15-20 nm, containing 7-8% Co, possessing hardness of 590 600 kg mm(2) and tensile strength of 1180-1200 MPa-significantly higher than the strength of pure nickel deposit which is produced by the similar method and gets similar grain size. (C) 2008 Elsevier B. V. All rights reserved.