Conversion treatments based on immersion in Cr(VI) aqueous solutions are key technologies that combine low cost, easy application and high performance. However, they are environmentally problematic due to their carcinogenity and genotoxicity. Among the potential alternatives, treatments based on rare-earth compounds have drawn attention due to the stability of their oxides and their environmental acceptability. Despite the amount of work published, there is not yet an industrially Suitable alternative treatment for aircraft aluminium alloys that is able to provide the required corrosion protection. A common feature of these alloys is the high level of copper in their chemical composition. Although the presence of copper in an alloy may enhance cerium deposition, high copper content alloys (AA2024, AA7075) have proven the most difficult to protect with Ce conversion coatings. In the present work, a commercial 8090-T8 aluminium alloy containing 1.15 weight percent (wt.%) Cu was coated with a Ce conversion coating at room temperature from a Ce bath without prior pretreatment of the specimens. Polarisation curves revealed that the presence of a cerium conversion coating (CeCC) reduces by two orders of magnitude the Corrosion rate of the AA8090 alloy in a sodium chloride solution. Impedance measurements exhibited capacitive behaviour for the CeCC up to 216h, showing that the cerium layer protects the bare alloy in the aggressive Solution. Electrochemical tests have therefore revealed that these conversion layers afford long-lasting protection; withstanding up to 168 h in Salt Spray test. (C) 2008 Elsevier Ltd. All rights reserved.