Micro-cogeneration, also termed micro combined heat and power (MCHP) or residential cogeneration, is an emerging technology with the potential to provide energy efficiency and environmental benefits by reducing primary energy consumption and associated greenhouse gas emissions. The distributed generation nature of the technology also has the potential to reduce losses due to electrical transmission and distribution inefficiencies and to alleviate utility peak demand problems. Detailed MCHP models for whole-building simulation tools, developed in Annex 42 of the International Energy Agency (IEA) Energy Conservation in Buildings and Community Systems Programme, have been used to conduct a performance assessment study for a number of micro-cogeneration systems and residential buildings. Annual non-renewable primary energy (NRPE) demand and CO2-equivalent (CO2-eq) emissions were determined by simulation for different cogeneration technologies, namely natural gas-fuelled solid oxide (SOFC) and polymer electrolyte membrane fuel cells, Stirling and internal combustion engines. These were compared to the reference system with a gas boiler and electricity supply from the grid. A ground-coupled heat pump system was also analysed for comparison. The cogeneration units were integrated in single and multi-family houses of different energy standard levels. Two different electricity generation mixes were considered: European mix and combined cycle power plant (CCPP). For the MCHP devices, detailed dynamic component models as well as simplified performance map models were used, developed and calibrated with either results from laboratory experiments or with manufacturer data. The simulations were performed using the whole-building simulation programme TRNSYS, using domestic hot water and electric demand profiles specified in [EA Annex 42. Combinations of three demand levels were analyzed. In NRPE demand, for the European electricity mix, most MCHP systems offered reductions (up to 34%) in comparison with the gas boiler reference system and crediting the electricity exported to the grid. For the CCPP electricity generation mix, the largest NRPE reductions resulted for the ground-coupled heat pump systems (up to 29%). The maximum reduction with a cogeneration system was 14%. In terms of CO2-eq emissions, most cogeneration systems offered reductions for the European electricity mix (up to 22%). However, maximum reductions resulted for the heat pump system (23%). For the CCPP mix, maximum reductions by far again resulted for the heat pump systems (up to 29%). The maximum reduction for a cogeneration system was achieved with the ICE system in the single-family house (14%). (C) 2008 Elsevier Ltd. All rights reserved.