Molten polymers are usually exposed to varying levels of shear flow and temperature gradient in most processing operations. Many Studies have revealed that the crystallization and morphology are significantly affected under shear. A so-called "skin-core" structure is usually formed in injection-molded semicrystalline polymers such as isotactic polypropylene (iPP) or polyethylene (PE). In addition, the presence of nucleating agent has great effect on the multilayered structure formed during injection molding. To further understand the morphological development in injection-molded products with nucleating agent, iPP with and without dibenzylidene sorbitol (DBS) were molded via both dynamic packing injection molding (DPIM) and conventional injection molding. The structure of these injection-molded bars was investigated layer by layer via SEM, DSC, and 2 days-WAXD. The results indicated that the addition of DBS had similar effect on the crystal size and its distribution as shear, although the later decreased the crystal size more obviously. The combination of shear and DBS lead to the formation of smaller spherulites with more uniform size distribution in the injection-molded bars of iPP. A high value of c-axis orientation degree in the whole range from the skin to the area near the core center was obtained in the samples molded via DPIM with or without DBS, while in samples obtained via conventional injection molding, the orientation degree decreased gradually from the skin to the core and the decreasing trend became more obvious as the concentration of DBS increased. (C) 2009 Wiley Periodicals, Inc. J Appl Polyrn Sci 112: 1104-1113, 2009