Structural composites with a high content of renewable material were produced from natural fibres and an acrylated epoxidized soybean oil resin. Composites were prepared by spray impregnation followed by compression moulding at elevated temperature. The resulting composites had good mechanical properties in terms of tensile strength and flexural strength. Tensile testing as well as dynamical mechanical thermal analysis showed that increasing the fibre content, increased the mechanical properties. The resin can be reinforced with up to 70 wt % fibre without sacrifice in processability. The tensile modulus ranged between 5.8 and 9.7 GPa depending on the type of fibre mat. The study of the adhesion by low vacuum scanning electron microscopy shows that the fibres are well impregnated in the matrix. The aging properties were finally evaluated. This study shows that composites with a very high content of renewable constituents can be produced from soy bean oil resins and natural fibres. (C) 2009 Wiley Periodicals, Inc. J Appl Polym Sci 114:2502-2508,2009