A numerical model for free-surface flow of a viscoplastic liquid into a cavity is presented. This flow is regarded as a basic model of injection molding, which is a widely used processing technology. Model experiments of the injection process are performed with a water-based gel with shear-thinning behavior. The filling process is visualized by tracing the free surface of the gel within the cavity. Filling times of the cavity are deduced from the experimental observations. The filling process is also analyzed by means of numerical simulation. The flow equations are integrated according to the finite-volume method. The volume-of-fluid method is employed in order to describe the flow of two incompressible, immiscible phases, the phase interface is resolved by the method of geometric reconstruction or alternatively by the method of surface compression. The Herschel-Bulkley model is used in order to describe the shear-thinning behavior of the gel and the effects of a yielding point. The governing equations of the flow are solved by means of the commercial code Fluent as well as the Open Source code OpenFOAM. The results of the numerical simulations are analyzed in detail. They are compared with the experimental findings. Cavity filling times in the experiments and the simulations are in good agreement. Different patterns of the filling flow depending on the injection parameters are evident in the experiments and the simulations. They are characterized and arranged with respect to the similarity parameters of the flow configuration. Again, the results of the simulation are found to agree well with the experimental observations. (C) 2009 Elsevier B.V. All rights reserved.