Covalent functionalization of alkyne-decorated multiwalled carbon nanotubes (MWNTs) with a well-defined, azide-derivatized, thermoresponsive diblock copolymer, poly(NN-dimethylacrylamide)-poly(N-isopropylacrylamide) (PDMA-PNIPAM) was accomplished by the Cu(I)-catalyzed [3 + 2] Huisgen cycloaddition. It was found that this reaction could simultaneously increase the molecular size and bonding density of grafted polymers when PDMA-PNIPAM micelles were employed in the coupling system. On the other hand, attachment of molecularly dissolved unimers of high-molecular weight onto the nanotube resulted in low-graft density. The block copolymer bearing azide groups at the PDMA end was prepared by reversible addition-fragmentation transfer polymerization, which formed micelles with a diameter of similar to 40 nm at temperatures above its critical micelle temperature. Scanning electron microscopy was utilized to demonstrate that the coupling reaction was successfully carried out between copolymer micelles and alkyne-bearing MWNTs. FTIR spectroscopy was utilized to follow the introduction and consumption of alkyne groups on the MWNTs. Thermogravimetric analysis indicated that the functionalized. MWNTs consisted of about 45% polymer. Transmission electron microscopy was utilized to image polymer-functionalized MWNTs, showing relatively uniform polymer coatings present on the surface of nanotubes. (C) 2008 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 46:7187-7199,2008