Hydrogen storage alloys La-0.7 Mg-0.3(Ni-0.9)Co-0.1)(x) (x = 3.0, 3.1, 3.3, 3.4, 3.5, 3.7 and 3.8) were prepared by inductive melting followed by annealing treatment at 1173 K for 6 h. The effects of the stoichiometry (x) on the structural and electrochemical characteristics of the alloys were investigated systematically. Xray diffraction (XRD). optical morphology and energy dispersive spectrometry (EDS) analyses showed that these alloys have a multiphase structure which consists of a (La, Mg)Ni-3 phase with the PuNi3-type rhombohedral structure, a LaNi5 phase with the CaCu5-type hexagonal structure and a (La, Mg)(2)Ni-7 phase with the Ce2Ni7-type hexagonal structure. The main phase of the alloys with x = 3.0 and 3.1 is (La, Mg)Ni-3 phase (PuNi3-type Structure), the main phase of the alloys with x = 3.3, 3.4 and 3.5 is (La, Mg)(2)Ni-7 phase (Ce2Ni7-type structure), and the main phase of the alloys with x = 3.7 and 3.8 is LaNi5 phase (CaCu5-type structure). Moreover, the lattice parameters of the (La, Mg)Ni-3 phase, (La, Mg)(2)Ni-7 phase and LaNi5 phase decrease monotonously with the increase of the value x. The electrochemical analysis shows that the maximum discharge capacity increases from 356.6 mA hg(-1) (x=3.0) to 392.1 mAh g(-1) (x=3.5) and then decreases to 344.1 mA hg(-1) (x=3.8), and the alloys exhibit good cycling stability. As the discharge Current density is 3000 mAg(-1). the high-rate dischargeability (HRD) increases from 30.1 % (x= 3.0) to 56.1 % (x=3.8). The low temperature dischargeability (LTD) increases from 24.3%(x=3.0) to 58.96% (x=3.7) and then decreases to 48.1 % (x = 3.8). (C) 2008 Elsevier B.V. All rights reserved.