Water-oxygen interactions and CO oxidation by water on the oxygen-precovered Au(111) surface were studied by using molecular beam scattering techniques, temperature-programmed desorption (TPD), and density functional theory (DFT) calculations. Water thermally desorbs from the clean Au(111) surface with a peak temperature of similar to 155 K; however, on a surface with preadsorbed atomic oxygen, a second water desorption peak appears at similar to 175 K. DFT calculations suggest that hydroxyl formation and recombination are responsible for this higher temperature desorption feature. TPD spectra support this interpretation by showing oxygen scrambling between water and adsorbed oxygen adatoms upon heating the surface. In further support of these experimental findings, DFT calculations indicate rapid diffusion of surface hydroxyl groups at temperatures as low as 75 K. Regarding the oxidation of carbon monoxide, if a (CO)-O-16 beam impinges on a Au(111) surface covered with both atomic oxygen (O-16) and isotopically labeled water ((H2O)-O-18), both (COO)-O-16-O-16 and (COO)-O-16-O-18 are produced, even at surface temperatures as low as 77 K. Similar experiments performed by impinging a C 16 0 beam on a Au(1 11) surface covered with isotopic oxygen (O-18) and deuterated water ((D2O)-O-16) also produce both (COO)-O-16-O-16 and (COO)-O-16-O-18 but less than that produced by using O-16 and (H2O)-O-18. These results unambiguously show the direct involvement and promoting role of water in CO oxidation on oxygen-covered Au(1 11) at low temperatures. On the basis of our experimental results and DFT calculations, we propose that water dissociates to form hydroxyls (OH and OD), and these hydroxyls react with CO to produce CO2. Differences in water-oxygen interactions and oxygen scrambling were observed between O-18/(H2O)-O-16 and O-18/(D2O)-O-16, the latter producing less scrambling. Similar differences were also observed in water reactivity toward CO oxidation, in which less CO2 was produced with O-16/(D2O)-O-16 than with O-16/(H2O)-O-16. These differences are likely due to primary kinetic isotope effects due to the differences in O-H and O-D bond energies.