The nitroxide-mediated copolymerization of 2-hydroxypropyl acrylate (HPA) with N-acryloylmorpholine (Amor) or N,N-dimethylacrylamide (DMA) was investigated using N-tert-butyl-N-(1'-diethylphosphono2,2'-dimethylpropyl)-O-(2-carboxyl-pr op-2-yl) (BlocBuilder) alkoxyamine initiator and additional free nitroxide (SG-1). Different reaction conditions, such as the concentration of additional SG-1, were tested to optimize the homopolymerizations using a Chemspeed ASW2000 automated parallel synthesizer. Best control for the hornopolymerizations (polydispersity indices of 1.2-1.3) of all three monomers was achieved using 20% additional SG-1 (relative to the initiator) at a reaction temperature of 110 degrees C for 2 M solutions in N,N-dimethylformamide and a monomer/initiator ratio of 100/1. Libraries of P(Amor-stat-HPA) and P(DMA-stat-HPA) were synthesized with 0-100 mol % HPA with 10 mol % increments using the optimized conditions obtained for the homopolymerizations. The resulting polymers had narrow molecular weight distributions, and their compositions, determined using H-1 NMR spectroscopy and elemental analysis, were close to the theoretical compositions. In addition, all copolymers of both libraries had single glass transition temperatures (T-g), and the transition temperatures decreased from the T-g of P(Amor) (147 degrees C) and P(DMA) (111 degrees C) to the T-g of P(HPA) (22 degrees C) with increasing HPA content. The cloud point of P(HPA) showed concentration dependence as well as a concentration dependent hysteresis. The cloud points of aqueous solutions of the copolymer libraries could be tuned from 21.4 to 88.0 degrees C and to 82.9 degrees C for P(Amor-stat-HPA) and P(DMA-stat-HPA), respectively, at a concentration of 1 wt %. LCST behavior was observed for copolymers with >40 wt % HPA in P(Amor-stat-HPA) and >55 wt % HPA in the P(DMA-stat-HPA) library.