It has been well established that one of most important factors to control the orientation of microdomains in block copolymer (BCP) Films is the wetting behavior of a BCP at the interface (or oil I substrate). From this perspective, we studied the wetting behavior of P(S-b-MMA) thin Films oil organosilicate (OS) interlayer dielectric layers (ILDs), which were employed as the target substrates for patterning by BCP lithography. We controlled file surface energy of OS substrates by varying the cure temperature or OS Substrates ranging from 200 to 400 degrees C. As the cure temperature was increased, the wetting behavior of a P(S-b-MMA) film oil the OS Substrate changed from the asymmetric to the symmetric wetting, as confirmed by AFM, which, in turn, allowed LIS to find the optimal cure temperature for neutral wetting behavior. As I result, we obtained perpendicularly oriented BCP microdomains on the OS substrate cured at 360 degrees C without further Surface modification. Finally we were able to transfer sub-25 nm BCP patterns directly onto the neutral ILD layers through reactive ion etching. The process approach taken here clearly demonstrates that file process involved in BCP lithography could be simplified by eliminating the additional Surface modification step on a target substrate.