MCM-41 mesoporous materials and silicoaluminophosphates (SAPO-5) were prepared by gel hydrothermal crystallization. Both series of materials were modified by transition metals (chromium or iron close to 1 wt%). The synthesized solids were characterized by chemical analysis, XRD, nitrogen adsorption-desorption isotherms. SEM. EPR, XPS, IR of ammonia or pyridine adsorption studies, and Si-29, Al-27 and P-31 NMR. The catalysts were evaluated in the n-butane isomerization in order to assess their properties with regard to alkane transformations. The properties of the solids were modified by adding metals that altered the morphology, structural features and acidic character of the solids and result in an efficient performance in the transformation of n-butane in comparison with the pure counterparts. The introduction of Cr or Fe enhanced the catalytic ability of silicoaluminophosphates to produce isobutane. Fe and Cr modified silicoaluminophosphates were shown to be more efficient in the transformation of n-butane in comparison with the MCM-41 analogues. However, the activity of these iron-containing molecular sieves was considered too low in comparison with performances of iron-modified modernite. This was ascribed to an initial redox C-4 activation step occurring in synergy with Bronsted sites with sufficient acid strength which is indeed higher than that provided by MCM-41 and SAPO molecular sieves. (C) 2010 Elsevier B.V. All rights reserved.