Gold nano-layers were deposited onto laser irradiated polyethyleneterephthalate (PET) surfaces. For irradiation, we used the linearly polarized light of a pulsed 248 nm KrF and 157 nm F-2 laser, respectively. In a certain range of irradiation parameters, the irradiation resulted in the formation of coherent ripples patterns with a lateral periodicity in the order of the wavelength of the laser light and with a corrugation height of several 10 nm. The deposited layers were then prepared by sputtering. The layers were analyzed by atomic force microscopy (AFM), focused ion beam (FIB) cuts, scanning electron microscopy (SEM), and angular resolved X-ray induced photoelectron spectroscopy (ARXPS). Gold sputtering on KrF laser irradiated PET led to the formation of separated "nano-wires'' at the ridges of the nano-patterns and not to a continuous metal layer, as we obtained in case of gold sputtering onto F-2 irradiated PET. The results of the XPS analysis indicated, that the KrF irradiation caused degradation on the ridge of the ripples, whereas no noticeable degradation occurred for F-2 laser treatment. We attribute the different growth mechanisms of the deposited gold layers mainly to the difference in surface chemical composition of laser irradiated PET with the two different lasers employed. (C) 2009 Elsevier B.V. All rights reserved.