Advancing and receding contact angles of water, formamide, glycerol and diiodometane were measured on the two polymers; EGDMA (dimethacrylate of ethylene glycol) and TRIM (trimethacrylate-1,1,1-trihydroksymethylopropane) which were polymerized next to glass, silanized glass, stainless steel, mica and silicon surfaces as the matrices. Then from the contact angle hystereses (CAH) and van Oss, Good, Chaudhury (LWAB) approaches the apparent surface free energies were evaluated. The measured contact angles not only depend solely on the polymer chemical structure but also, to some extent, on the solid matrix next to whose surface the sample has polymerized. Surface free energy of the polymer samples calculated from the LWAB approach shows that they interact mainly by dispersive forces. The apparent surface free energy of the polymers calculated from the diiodomethane contact angles hysteresis is practically the same irrespective of the kind of the matrix used. Therefore it can be concluded that the observed weak polar interactions in the surface free energy of the samples depend on the polymer surface preparation. The AFM images show that the obtained surfaces are of different roughness. The RMS values of roughness range between 3.7-90.2 nm for EDGMA, and 5.3-124.5 nm for TRIM. However, as reported in literature, rather protrusions bigger than 1 mm may significantly affect the contact angles, especially the receding ones. (C) 2010 Elsevier B. V. All rights reserved.