BACKGROUND: The energy demand of distillation-based systems for ethanol recovery and dehydration can be significant, particularly for dilute solutions. An alternative separation process integrating vapor stripping with a vapor compression step and a vapor permeation membrane separation step, termed membrane assisted vapor stripping (MAVS), has been proposed. The hydrophilic membrane separates the ethanol-water vapor into water-rich permeate and ethanol-enriched retentate vapor streams from which latent and sensible heat can be recovered. The objective of this work was to demonstrate experimentally the performance of a MAVS system and to compare the observed performance with chemical process simulation results using a 5 wt% ethanol aqueous feed stream as the benchmark. RESULTS: Performance of the steam stripping column alone was consistent with chemical process simulations of a stripping tower with six stages of vapor liquid equilibria (VLE). The overhead vapor from the stripper contained about 40 wt% ethanol and required 6.0 MJ of fuel-equivalent energy per kg of ethanol recovered in the concentrate. Introduction of the vapor compressor and membrane separation unit and recovery of heat from both membrane permeate and retentate streams resulted in a retentate ethanol concentrate containing ca 80 wt% ethanol, but requiring only 2.2 MJ fuel kg(-1) ethanol, significantly less than steam stripping alone. CONCLUSION: Performance of the experimental unit with a 5 wt% ethanol feed liquid corroborated chemical process simulation predictions for the energy requirement of the MAVS system, demonstrating a 63% reduction in the fuel-equivalent energy requirement for MAVS compared with conventional steam stripping or distillation. Published 2009 by John Wiley and Sons, Ltd.