A newly-developed, highly conductive, and cost-effective LaAlO3-based perovskite was used as a solid electrolyte to replace costly LaGaO3 in this study. The La0.9Ba0.1Al0.9Y0.1O3 (LBAYO) solid electrolyte was fabricated by codoping 10 at.% Ba and 10 at.% Y into the cation sublattice of LaAlO3. The conductivity of the doubly doped La0.9Ba0.1Al0.9Y0.1 O-3 was enhanced to 184 x 10(-4) S cm(-1) which is about 50 times higher than that of the undoped one at 800 degrees C. Cathode-supported cells consisting of Ni/yttria-stabilized zirconia (Ni/YSZ) anode, a thin LBAYO electrolyte (similar to 63 mu m), a samarium doped ceria (SDC) interlayer, and a lanthanum strontium manganite (LSM) cathode were assembled and tested. The LBAYO electrolyte film was first prepared on conductive LSM substrates using the electrophoretic deposition (EPD) technique. The cathode-supported structure, consisting of an LBAYO film on a porous LSM substrate, was co-fired at 1450 degrees C for 2 h. A crack-free LBAYO film with a uniform thickness supported on a porous LSM substrate was obtained. Subsequently, a 10 mu m-thick SDC buffer interlayer between the electrolyte and 30 mu m-thick NiO/YSZ anode was screen-printed and fired on the electrolyte film. A 10-day test showed essentially no degradation on the output power from the cell using the LBAYO electrolyte. These tests convincingly demonstrated the feasibility of an SOFC using LBAYO as the electrolyte when operated at temperatures ranging from 600 degrees C to 800 degrees C. (C) 2010 Elsevier B.V. All rights reserved.