The energy wood procurement possibilities for the eight regions making up Northwest Russia were assessed. Wood byproducts from logging and mechanical wood processing were considered for energy production based on actual cut, sawmill and plywood production figures for 2006. Of the total calculated potential of 31 million solid m(3) (62 TWh), nearly 70% (21.8 million m(3)) is from logging. The remainder (9 million m(3)) is from sawmill and plywood production. The approximate available energy wood by region would be: 2.3 million m(3) from the Republic of Karelia, 2.7 million m(3) from the Republic of Komi, 5.4 million m(3) from Arkhangelsk, 4.6 million m(3) from Vologda, 3.8 million m(3) from Leningrad, 2.0 million m(3) from Novgorod, 0.8 million m(3) from Pskov, and 41,000 m(3) from the Murmansk region. There are large differences in the potentials between and within the regions. This is due to the differences in their forest resources; differences in their utilisation of these resources; the available infrastructures; and some limitations on logging. Nearly 65% of all the potential energy wood from logging is non-industrial roundwood, 19% is spruce stumps removed after final felling, 8% is unused branches and tops, and 8% is defective wood resulting from logging. About 58% of the total potential energy wood from logging is coniferous. However, there are large differences between the regions and within the regions in the species proportions. Currently about 40% of the allowable cut is used. This means that it would be possible to intensify the utilisation of the forest resources and thereby also to increase the use of wood for energy production. Full implementation of the allowable cut could provide 73.5 million m(3) of energy wood (147 TWh). In addition, if the technical potential for thinnings is utilised, the total potential energy wood provided by logging, and mechanical wood processing could be 104 million m(3) (208 TWh). (C) 2010 Elsevier Ltd. All rights reserved.