A sulfonated poly(sulfone) (S-Radel(A (R))) membrane with high proton conductivity and low vanadium ion permeability showed high initial performance in a vanadium redox flow battery (VRFB) but suffered mechanical and chemical degradation during charge/discharge cycling. The S-Radel membrane showed different degradation behavior in flow cell cycling and ex-situ vanadium ion immersion tests. When the membrane was immersed in aqueous V(5+) solution, the sample cracked into small pieces, but did not degrade to any measurable extent in V(4+) solution. During charge/discharge cycling in the VRFB cell, the membrane underwent internal delamination, preferentially on the side of the membrane that faced the positive electrode. A vanadium-rich region was observed near the membrane surface that experienced delamination and Raman spectroscopic analysis of the degraded surface indicated a slightly depressed 1026 cm(-1) band corresponding to a loss in the sulfonate SO(2) stretch intensity. Even though the S-Radel membrane underwent severe mechanical damage during the flow cell cycling, significant chemical degradation was not obvious from the spectroscopic analyses. For the VRFB containing an S-Radel membrane, an increase in membrane resistance caused an abnormal voltage depression during the discharge cycle. The reversible increase in membrane resistance and severe mechanical degradation of the membrane during cycling may be attributed to repeated formation and dissolution of particles inside the membrane. The mechanical stresses imposed by the particles coupled with a small amount of chemical degradation of the polymer by V(5+) ions, are likely degradation mechanisms of the S-Radel membrane in VRFBs under high state-of-charge conditions.