LiNi0.5Mn1.5O4 with a spinel structure was prepared by drip pyrolysis in a fluidized bed reactor followed by a short heat treatment from a precursor solution; in which Li(CH3COO)center dot 2H(2)O, Ni(CH3COO)(2)center dot 4H(2)O and Mn(CH3COO)(2)center dot 4H(2)O were stoichiometrically dissolved into distilled water. The effect of process parameters such as reactor temperature, superficial gas velocity and annealing temperature on the physical and electrochemical properties of samples were intensively investigated through analysis by X-ray diffraction, thermal gravimetric-differential thermal-mass analysis, Bruneaur-Emment-Teller method and scanning electron microscopy. The samples prepared by the drip pyrolysis showed a spinel structure with low crystallinity and poor electrochemical activity. Thus, the as-prepared samples were then annealed at different temperatures ranging from 700 to 900 degrees C for 5 h. Complex analysis showed that the annealing at 700 degrees C leads to the formation of a pure ordered P4(3)32 phase, while the annealing at 800 and 900 degrees C leads to the formation of both spinel Fd3m (disordered) and simple cubic P4(3)32 (ordered) phases. The final LiNi0.5Mn1.5O4 samples were used as cathode active materials for lithium batteries, and electrochemical tests were carried out for the cell Li|1M LiPF6 in EC : DEC = 1 : 1| LiNi0.5Mn1.5O4 at various charge-discharge rates. As a result, the LiNi0.5Mn1.5O4 sample, which was synthesized at 600 degrees C and a fluidization number of U-o/U-mf = 5 followed by heat treatment at 800 degrees C for 5 h, delivered a first discharge capacity of 127mAhg g(-1) at 0.1 C rate. Furthermore, it also showed excellent capacity retention at 1 C of more than 92% after 100 cycles.