Polymer brushes of water-soluble polymers, poly(2-hydroxyethyl acrylate) (PHEA) and poly(poly(oxyethyleneglycol)methylether acrylate) (PPEGA), were synthesized on a silicon wafer and a silica particle by applying photo-induced organotellurium-mediated radical polymerization to surface-initiated graft polymerization. High graft densities were obtained, corresponding to reduced graft densities of about 0.32 and 0.42 for the PHEA and PPEGA brushes, respectively. These values were high enough to be categorized in the regime of "concentrated" polymer brushes (CPBs). Atomic force microscopic (AFM) study revealed that the CPB of PPEGA was allowed to be highly swollen in water but the CPB of PHEA did not. This means that water is reasonably good for PPEGA but not for PHEA. The AFM microtribological study between swollen brushes revealed two lubrication regimes, namely, boundary-and hydrodynamic-lubrication regimes, with different shear-velocity dependencies. Reflecting insufficient quality of water as a solvent, the CPB of PHEA showed adhesive interaction and thereby a higher frictional coefficient l in the boundary lubrication. More interestingly, super lubrication was achieved for the CPB of PPEGA with a l value in the order of 10(-4) in water and in 0.1 M aqueous NaCl solution (without the help of electrostatic repulsion). Super lubrication was concluded to be a characteristic feature of the CPB, even in an aqueous system. (C) 2011 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 49: 5284-5292, 2011