The systematic evaluation of the degradation of an amorphous cellulose film by a monocomponent endoglucanase (EG I) by using a quartz crystal microbalance with dissipation monitoring (QCM-D) identified several important aspects relevant to the study the kinetics of cellulose degradation by enzymes. It was demonstrated that, to properly evaluate the mechanism of action, steady state conditions in the experimental set up need to be reached. Rinsing or diluting the enzyme, as well as concentration of the enzyme, can have a pronounced effect on the hydrolysis. Quantification of the actual hydrolysis was carried out by measuring the film thickness reduction by atomic force microscopy after the enzymatic treatment. The values correlated well with the frequency data obtained by QCM-D measurement for corresponding films. This demonstrated that the evaluation of hydrolysis by QCM-D can be done quantitatively. Tuning of the initial thickness of films enabled variation of the volume of substrate available for hydrolysis which was then utilized in establishing a correlation between substrate volume and hydrolytic activity of EG I as measured by QCM-D. It was shown that, although the amount of substrate affects the absolute rate of hydrolysis, the relative rate of hydrolysis does not depend on the initial amount of substrate in steady state system. With this experimental setup it was also possible to demonstrate the impact of concentration on crowding of enzyme and subsequent hydrolysis efficiency. This effort also shows the action of EG I on a fully amorphous substrate as observed by QCM-D. The enzyme was shown to work uniformly within the whole volume of swollen film, however being unable to fully degrade the amorphous film.