A series of thermo-responsive cationic triblock copolymers composed of methoxypoly(ethylene glycol) (MPEG, hydrophilic), poly(N-isopropylacrylamide) (PNIPAAM, temperature sensitive), and poly((3-acrylamidopropyl) trimethyl ammonium chloride) (PN(+), cationic) has been investigated a:; a function of temperature and ionic strength. In the MPEG-b-PNIPAAM-b-PN(+) copolymers, the MPEG block length is constant, and the lengths of the PNIPAAM and PN(+) blocks are varied. The solubility of the PNIPAAM block decreases with increasing temperature, and the triblock copolymer thus provides the possibilities of studying micelles with both neutral and charged blocks in the micelle corona as well as the interplay between these two blocks as the electrostatic interactions are varied by addition of salt. Investigation of the systems by densitometry and small-angle X-ray scattering (SAXS) in a temperature range from 20 to 70 degrees C gave detailed information on the behavior both below and above the critical micelle temperature (CMT). A clear effect of the addition of salt is observed in both the apparent partial specific volume, obtained from the densitometry measurements, and the SAXS data. Below the CMT, the single polymers can be described as Gaussian chains, for which the repulsive interchain interactions, originating from the charged PN(+) block, have to be taken into account in salt-free aqueous solution. Increasing the salt concentration of the solution to 30 mM NaCl leads to an increase in the apparent partial specific volume, and the electrostatic repulsive interchain interactions between the single polymers vanish. Raising the temperature results in micelle formation, except for the copolymer with only 20 NIPAAM units. The SAXS data show that the polymer with the medium PNIPAAM block length forms spherical micelles, whereas the polymer with the longest PNIPAAM block forms cylindrical micelles. Increasing the temperature further above the CMT results in an increase in the micellar aggregation number for both of the polymers forming spherical and cylindrical micelles. The addition of salt to the solution also influences the aggregates formed above the CMT. Overall, the micelles formed in the salt solution have a smaller cross-section radius than those in aqueous solution without added salt.