Although it is known that foaming a surfactant solution results in a depletion of the surfactant in the bulk phase, this effect is often overlooked and has never been quantified. Therefore, the influence of surfactant depletion on foam properties using solutions of the two nonionic surfactants, n-dodecyl-beta-D-maltoside (beta-C(12)G(2)) and hexaethyleneglycol monododecyl ether (C12E6), were investigated. These investigations were conducted in two steps. First, different foam volumes were generated with the same surfactant solution at a concentration of c = 2 cmc. It was found that the higher the foam volume, the larger the surfactant depletion. Second, two different bulk concentrations (c = 2 and 1.33 cmc) were used for the generation of 50 and 110 mL of foam, respectively. For a foam volume of 50 mL, no differences were observed, whereas generating 110 mL led to different results. The surfactant loss in the bulk solution was measured via surface tension measurements and then compared to the results of purely geometric considerations that take into account the amount of interface created in the foam. Both results were in very good agreement, which means that surfactant depletion can be calculated in the way suggested here. Under conditions where depletion plays a role, our approach can also be used to estimate the bubble size of a foam of known volume by measuring the surfactant concentration in the bulk solution after foaming.