Cu-4.5Cr and Cu-4.5Cr-3Ag (in wt%) alloys without or with 10 wt% nanocrystalline Al2O3 and ZrO2 dispersion have been synthesized by mechanical alloying or milling and consolidated by laser assisted sintering in Ar atmosphere. Microstructural characterization by scanning and transmission electron microscopy and phase analysis by X-ray diffraction suggest that the alloyed matrix undergoes significant grain growth after sintering while the dispersoids retain their ultrafine size and uniform distribution in the matrix. The dispersion of nano-Al2O3 is more effective than that of nano-ZrO2 in enhancing the mechanical properties due to the smaller initial particle size of Al2O3 than that of ZrO2. In general, laser sintering of mechanically alloyed Cu-4.5Cr and Cu-4.5Cr-3Ag alloys with 10 wt% nanocrystalline Al2O3 at 100W laser power and 1-2 mm s(-1) scan speed yields the optimum combination of high density (7.1-7.5 mg m(-3)), hardness (165-225 VHN), wear resistance and electrical conductivity (13-20% IACS). (C) 2011 Elsevier B.V. All rights reserved.