Thin films of unmodified and nanoclay-modified polylactide/poly(butylene succinate) (PLA/PBS) blends were prepared on a glass substrate with a spin coater. The morphology and crystal growth behaviours for the films, crystallized at different temperatures, were visualized with atomic force microscope (AFM). AFM images showed that the size of the dispersed PBS phase was reduced on the addition of 2 wt% clay to the PLA/PBS blend, and the size of the dispersed phase increases with the further addition of clay. Transmission electron microscopy studies indicated that this behaviour was due to the preferential location of silicates in the PBS phase than in the PLA phase. A similar effect of clay to the blend thin, films on the dispersed phase and the crystalline morphology were observed when annealed at 60 degrees C and 120 degrees C. However, at 60 degrees C the addition of clay to the blend quenched the growth of edge-on lamellae. The crystalline morphologies at 120 degrees C were dominated by edge-on lamellae grown around the PBS phase to form spherulites. Morphologies of thin films crystallized at 120 degrees C from melt were dominated by the flaton lamellae, while the ones crystallized at 70 degrees C from melt were dominated by the edge-on lamellae. The degree of clay silicate dispersion in the blend matrix was characterized by X-ray diffraction. These results show how the crystallization temperatures and the addition of the clay particles influence the morphology of the thin films. (c) 2012 Elsevier Ltd. All rights reserved.