The enzyme-based cleaning of two model protein soils was investigated using a scanning fluid dynamic gauge (sFDG). The sFDG device allows data to be collected from more than one sample or location during a single experiment and therefore makes a range of comparative studies feasible. The sFDG was modified to allow the forces imposed on the surface to be controlled during a test. Gelatine films on stainless steel swelled in the presence of alkali at 20 degrees C but were not removed. Enzymes from a commercial dishwasher product interrupted swelling when the mean water volume fraction of the film reached similar to 0.9 and promoted removal. The enzyme effectiveness decreased over time. Egg yolk deposits (spray dried on mica) were studied in a protease/buffer solution at 40 degrees C. The deposits swelled on contact with alkali, and removal started after similar to 40 min. Some flow over the deposit was required to achieve complete cleaning, but the time taken to clean exhibited a weak dependence on the shear stress imposed by the flow for shear stresses above 10 Pa. The cleaning behaviour was strongly influenced by the nature of the deposit. Baking the deposit at 150 degrees C reduced the rate and extent of swelling as well as the rate of removal, and could result in the formation of a residual film that exhibited yield stress characteristics. (C) 2011 The Institution of Chemical Engineers. Published by Elsevier B.V. All rights reserved.