화학공학소재연구정보센터
Combustion and Flame, Vol.159, No.6, 2056-2068, 2012
Numerical analysis of the influence of two-phase flow mass and heat transfer on n-heptane autoignition
This paper investigates the influence of liquid fuel presence on the autoignition of n-heptane/air mixtures over a wide range of conditions encountered in internal combustion engines. To this end, evaporating droplet physics and skeletal chemistry mechanisms are simultaneously solved considering a homogeneous constant-pressure reactor. A skeletal mechanism is introduced to account for specific kinetics behavior in the Negative Temperature Coefficient (NTC) region. The impact of mass and heat source terms during evaporation is emphasized by comparing a two-phase flow scenario with a purely gaseous case. The competition between fuel vapor availability and the evaporation-induced gas temperature decrease is specific to two-phase flow autoignition. On the one hand, droplet evaporation delay restricts the gaseous local fuel/air equivalence ratio and consequently the kinetics runaway. On the other hand, temperature reduction due to evaporation may either reduce or enhance chemical reactivity, depending on the local thermodynamic conditions lying either inside or outside the NTC region. By simultaneously accounting for evaporation source terms and skeletal chemistry, we can reproduce the already experimentally observed transformation of the NTC region into a Zero Temperature Coefficient (ZTC) region depending on thermodynamic conditions and droplet size. The ZTC phenomenon appears when combustion heat-release starts before complete droplet evaporation. Since the ZTC behavior can be captured using the point source approach, in which droplets are considered only as zero-dimensional source terms of mass and energy, the present results pave the way for future exploration of NTC chemistry in sprays with a direct numerical simulation of discrete particles considering detailed chemistry and turbulent flows. (C) 2012 The Combustion Institute. Published by Elsevier Inc. All rights reserved.