Direct liquefaction of lignocellulosic wastes (sawdust and cornstalks) and two model bio-mass compounds (pure lignin and pure cellulose as references) has been conducted in hot-compressed water at temperatures from 250 to 350 degrees C in the presence of 2 MPa H(2), for the production of phenolic compounds that may be Suitable for the production of green phenol-formaldehyde resins. The liquefaction operations at 250 degrees C for 60 min produced the desirable product of phenolic/neutral oil at a yield of about 53, 32, 32 and 17 wt.% for lignin, sawdust. cornstalk and cellulose, respectively. The yield of phenolic/neutral oil for each feedstock was found to decrease with increasing temperature. As evidenced by GC-MS measurements, significant quantities of phenolic compounds such as 2-methoxy-phenol, 4-ethyl-2-methoxyphenol, and 2,6-dimethoxy-phenol, were present in the resulting phenolic/neutral oils from the two lignocellulosic wastes and pure lignin. The relative concentration of phenolic compounds in the lignin-derived oil was as high as about 80%. As expected, the liquid products from cellulose contained essentially carboxylic acids and neutral compounds. Addition of Ba(OH)(2) and Rb(2)CO(3) catalysts were found to significantly increase both phenolic/neutral oil and gas yields for all feedstocks except for lignin. (C) 2009 Elsevier Ltd. All rights reserved.