Carbon supported PtRuMo nanoparticles for CO and methanol electrooxidation have been prepared using different Mo precursors (MoCl(5), (NH(4))(6)Mo(7)O(24) and MoO(3)). Electrocatalysts as well as support characterization has been carried out through various physicochemical (XRD, TEM, XPS, TPR and TXRF) and electrochemical techniques as cyclic voltammetries and current-time curves, applied in combination with differential electrochemical mass spectrometry (DEMS). MoO(3) precursor was mainly used as representative of Mo(6+) species in the electrocatalyst. The results of this work pointed out that irrespectively of the similar structure and particle size are obtained using MoCl(5) and (NH(4))(6)Mo(7)O(24), the final composition and homogeneity of the ternary catalysts were found to depend markedly on these precursors. MoCl(5) led to a dramatic loss of Mo, while (NH(4))(6)Mo(7)O(24) appeared to be more stable and handy for synthesis of PtRuMo nanoparticles. Once the catalysts have been stabilized in the electrode, similar Mo species, mainly Mo(5+), are formed on the catalysts surface of all PtRuMo catalysts. This is indicative that similar metal-support and metal-metal interactions are likely developed in carbon supported PtRuMo nanoparticles at these potential conditions. The possible metal interactions that take place and the lower oxidation states of surface Mo species may be responsible of the high activity in CO and methanol electrooxidation as compared with binary and ternary catalysts obtained with MoO(3). The higher activity observed using (NH(4))(6)Mo(7)O(24) as precursor could be finally attributed to the composition and a remarkable Ru-Mo interaction detected by TPR. Finally, the MoO(3)-loaded catalyst proves that high oxidation states of Mo not only result in high losses of metals during the stabilization of the system and lower activities but also affect negatively the development of Pt-Ru interactions. (C) 2010 Elsevier B.V. All rights reserved.