Refined hazelnut, walnut and high-oleic peanut oils were converted into fatty acid methyl esters using catalytic sodium methoxide and evaluated as potential biodiesel fuels. These feedstocks were of interest due to their lipid production potentials (780-1780 L ha (1) yr (1)) and suitability for marginal lands. Methyl oleate was the principal constituent identified in hazelnut (HME; 76.9%) and peanut (PME; 78.2%) oil methyl esters. Walnut oil methyl esters (WME) were comprised primarily of methyl esters of linoleic (60.7%), oleic (15.1%) and linolenic (12.8%) acids. PME exhibited excellent oxidative stability (IP 21.1 h; EN 14112) but poor cold flow properties (CP 17.8 degrees C) due to its comparatively high content of very-long chain fatty esters. WME provided low derived cetane number and oxidative stability (IP 2.9 h) data as a result of its high percentage of polyunsaturated fatty esters. HME yielded a satisfactory balance between all fuel properties when compared to the biodiesel standards ASTM D6751 and EN 14214 due to its high content of monounsaturated fatty esters. Also explored were the properties of blends of HME, PME and WME in ultra-low sulfur (<15 ppm) diesel (ULSD) fuel and comparison to petrodiesel standards ASTM D975, D7467 and EN 590. With increasing content of biodiesel, the oxidative stability, cold flow properties and calorific value of ULSD was negatively affected, whereas lubricity was markedly improved. Kinematic viscosity, specific gravity and surface tension were impacted to lesser extents by addition of biodiesel to ULSD. In summary, HME, PME and WME are suitable based on their fuel properties as biodiesel fuels and blend components in ULSD. Published by Elsevier Ltd.