To avoid the negative effects caused by fouling in heat exchanger equipment, the heat exchanger surface can be modified energetically or mechanically. Thus, mechanical, chemical, and thermal stability of the coatings with respect to the fouling and cleaning conditions is crucial. The surface is typically characterized by the measurement of the contact angles of different wetting fluids to calculate surface energy and tactile roughness measurements. The influence of several cleaning and fouling cycles on surface energy and the composition of the coatings has been investigated. The experimental investigation of different cleaning methods from acid to base solution displays the influence of the interface reactions on the surface energy. Structural analysis of the plasma-activated chemical vapor deposition (PACVD) coatings show a build-in of oxygen inside the a-C: H matrix with time, resulting in higher surface energies and an increase of polar interactions. Also, structural defects of the coatings have been analyzed by a defined disturbance of the coating process or mechanical treatment of the already coated material. These defects act as a starting point for crystallization fouling due to reduced activation energy of nucleation. Depending on the interface and process conditions, defects can enhance fouling if the crystals are able to adhere on the coated surface. The results should lead to a better understanding of interface reactions, stability of coatings, and the aging of surfaces.