| 학회 |
한국화학공학회 |
| 학술대회 |
2004년 가을 (10/29 ~ 10/30, 호서대학교(아산캠퍼스)) |
| 권호 |
10권 2호, p.2017 |
| 발표분야 |
이동현상 |
| 제목 |
Development of transient-integrated gas flow model and its evaluation in gas assisted injection molding |
| 초록 |
There were some exceptional cases that RT1 or RT2 were not consistent with the simulation results (i.e., flow directions). Thus such a developed model as time-dependent model was required to describe transient behavior of the interface between gas phase and resin phase instead of comparison of initial velocities in upper side and lower side of the configuration, which was proposed and utilized to compare with the results of Moldflow in this 2nd part of the paper. The predictions of developed flow model were so quite consistent to the results of simulation that the proposed time-dependent flow model may be referred to describe very well the transient behavior of the movement of the interface of gas and melt-resin in the cavities. In addition time–dependent model was also established and was used to compare with the results of Moldflow when cavities of pipes and runners were involved in configuration. It is amazing that the proposed developed model was able to predict exactly the cross-over between the trajectories of interface of upper and lower side. |
| 저자 |
임광희, 홍수현
|
| 소속 |
대구대 |
| 키워드 |
transient-integrated gas flow model; gas assisted injection molding
|
| E-Mail |
|
| 원문파일 |
초록 보기 |
