| 150 - 158 |
Swelling Properties and Environmental Responsiveness of a Superabsorbent Composite Microsphere Based on Starch-g-Poly(acrylic acid)/Organo-Mordenite
Gao PQ, Zhang Y, Zhao L, Chen YZ |
| 159 - 164 |
Study on Permeability of Porous Ultra-High Molecular Weight Polyethylene (UHMWPE)
Jiang BY, Zhou MY, Weng C, Li CF |
| 165 - 173 |
Precise Fabrication of Fresnel Flash Lens Featured with V-Grooved Microstructures
Huang MS, Chen YC |
| 174 - 182 |
Ion Etching Induced Surface Patterns of Blend Polymer (Poly Ethylene Glycol - Poly Methyl Methacrylate) Irradiated with Gamma Rays
Ghobashy MM, Reheem AMA, Mazied NA |
| 183 - 193 |
Devulcanization of Scrap Tire Rubber with Supercritical CO2: A Study of the Effects of Process Parameters on the Properties of Devulcanized Rubber
Meysami M, Tzoganakis C, Mutyala P, Zhu SH, Bulsari M |
| 194 - 202 |
Forming of Thermoplastic Matrix Composites with Gas Pressure - the Influence of Blank Holder and Sheet Temperature on the Forming Pressure and Drawing Ratio
Groschel C, Drummer D |
| 203 - 208 |
Time Dependence of Morphology and Mechanical Properties of Injection Molded Recycled PET
Molnar B, Ronkay F |
| 209 - 216 |
A Generalized 2D Output Model of Polymer Melt Flow in Single-Screw Extrusion
Pachner S, Low-Baselli B, Affenzeller M, Miethlinger J |
| 217 - 226 |
Flow Behavior of PP-Polymer Nanocomposites in Capillary and Injection Molding Dies
Mitsoulis E, Battisti M, Neunhauserer A, Perko L, Friesenbichler W |
| 227 - 236 |
A Recollection with Respect to Flow Induced Crystallization in Polymer Melt Processing
Janeschitz-Kriegl H |
| 237 - 244 |
Optical Properties of HDPE in Injection Molding and Injection Press Molding for IR System Lenses Part II: Mold Temperature and Surface Roughness Effects on Injection Molding
Kaneda R, Takahashi T, Takiguchi M, Hijikata M, Ito H |
| 245 - 252 |
Modeling Temperature and Time Dependence of the Wetting of Tool Steel Surfaces by Polymer Melts
Zitzenbacher G, Langauer M, Holzer C |
| 253 - 259 |
Modification Induced by Gamma Irradiation in Polystyrene/Poly(methyl methacrylate) Blends
Nouh SA, Benthami K, Abou Elfadl A, El-Nabarawy HA |
| 260 - 264 |
Study on the Influence of Extrusion Temperature and Extrusion Die on the Properties of Self-Reinforced PP Sheets
Wen S, Du WW, Douadji L |
