1 - 6 |
Photoelectrochemical performance of spray-deposited Fe-doped ZnS0.2Se0.8 thin films Patil NM, Nilange SG, Yadav AA |
7 - 18 |
Design optimization of building geometry and fenestration for daylighting and energy performance Fang Y, Cho S |
19 - 33 |
Thermal analysis of fluidized particle flows in a finned tube solar receiver Le Gal A, Grange B, Tessonneaud M, Perez A, Escape C, Sans JL, Flamant G |
34 - 45 |
All-weather characteristic studies of a direct expansion solar integrated air source heat pump system based on PCMs Wu JH, Xian T, Liu X |
46 - 56 |
Theoretical and experimental study on selection of physical dimensions of passive solar greenhouses for enhanced energy performance Chen C, Yu N, Yang FG, Mahkamov K, Han FT, Li YR, Ling HS |
57 - 69 |
Design and simulated performance of a solar-thermal system employing seasonal storage for providing the majority of space heating and domestic hot water heating needs to a single-family house in a cold climate Beausoleil-Morrison I, Kemery B, Wills AD, Meister C |
70 - 77 |
Holey g-C3N4 nanosheet wrapped Ag3PO4 photocatalyst and its visible-light photocatalytic performance Wang HR, Lei Z, Li L, Wang X |
78 - 83 |
Three-dimensional ZnO/ZnxCd1-xS/CdS nanostructures modified by microwave hydrothermal reaction-deposited CdSe quantum dots for chemical solar cells Zhao R, Zhong JY, Ji C, Zhao JT, Lu H |
84 - 99 |
One-way fluid-structure interaction of a medium-sized heliostat using scale-resolving CFD simulation Wolmarans JR, Craig KJ |
100 - 108 |
Study of the multi-equilibria of red wine colorants pyranoanthocyanins and evaluation of their potential in dye-sensitized solar cells Pinto AL, Oliveira J, Araujo P, Calogero G, de Freitas V, Pina F, Parola AJ, Lima JC |
109 - 137 |
Review on greenhouse microclimate and application: Design parameters, thermal modeling and simulation, climate controlling technologies Choab N, Allouhi A, El Maakoul A, Kousksou T, Saadeddine S, Jamil A |
138 - 150 |
Comparison of statistical post-processing methods for probabilistic NWP forecasts of solar radiation Bakker K, Whan K, Knap W, Schmeits M |
151 - 160 |
Highly supportive hydrogen peroxide as a hole scavenger to improve the visible light water splitting activity of flake-like Co-doped ZnO thin films Sreedhar A, Reddy IN, Ta QTH, Cho E, Noh JS |
161 - 166 |
Experimental study of observed defects in mini-modules based on crystalline silicone solar cell under damp heat and thermal cycle testing Faye I, Ndiaye A, Gecke R, Blieske U, Kobor D, Camara M |
167 - 179 |
Numerical analysis of evacuated tube solar collectors using nanofluids Mercan M, Yurddas A |
180 - 192 |
Hydrodynamic and thermodynamic enhancement of a solar chimney power plant Aligholami M, Khosroshahi SS, Khosroshahi AR |
193 - 204 |
An agent-based approach to modeling zero energy communities Mittal A, Krejci CC, Dorneich MC, Fickes D |
205 - 209 |
Cupric oxide film with a record hole mobility of 48.44 cm(2)/Vs via direct-current reactive magnetron sputtering for perovskite solar cell application Gao XY, Du YL, Meng X |
210 - 218 |
A new uniformity coefficient parameter for the quantitative characterization of a textured wafer surface and its relationship with the photovoltaic conversion efficiency of monocrystalline silicon cells Xu ZL, Xu XP, Cui CC, Huang H |
219 - 226 |
Efficient non-fullerene organic solar cells based on thickness-insensitive conjugated small molecule cathode interface Li JL, Liu JK, Zhang JB, Ma JM, Hu Y, Xie GS, Zhang J, Tu GL |
227 - 234 |
Optimal PV panel's end-life assessment based on the supervision of their own aging evolution and waste management forecasting Hocine L, Samira KM |
235 - 250 |
Comparison and analysis of performance and degradation differences of crystalline-Si photovoltaic modules after 15-years of field operation de Oliveira MCC, Cassini DA, Diniz ASAC, Soares LG, Viana MM, Kazmerski LL, Lins VDC |
251 - 262 |
Photocatalytic nitrogen fixation over fluoride/attapulgite nanocomposite: Effect of upconversion and fluorine vacancy Li XZ, He CL, Zuo SX, Yan XY, Dai DY, Zhang Y, Yao C |
263 - 271 |
Enhanced performance of carbon-based planar CsPbBr3 perovskite solar cells with room-temperature sputtered Nb2O5 electron transport layer Zhao F, Guo YX, Wang X, Tao JH, Jiang JC, Hu ZG, Chu JH |
272 - 290 |
Extended model for irradiation suitable for large bifacial PV power plants Durkovic V, Durisic Z |
291 - 299 |
In situ fabrication of Cu2-xSe networks nanostructure counter electrode based on Ti substrate via sacrifice template method for quantum dot sensitized solar cells Chen YF, nWag DJ, Lin YH, Zou XX, Xie TF |
300 - 310 |
Performance enhancement of bulk heterojunction organic solar cells using photon upconverter Hakim F, Alam MK |
311 - 322 |
Predicting the solar evaporative cooling performance of pervious materials based on hygrothermal properties Wang JS, Santamouris M, Meng QL, He BJ, Zhang L, Zhang Y |
323 - 331 |
Optical characterisation of oxidised carbon nanohorn nanofluids for direct solar energy absorption applications Gimeno-Furio A, Hernandez L, Barison S, Agresti F, Cabaleiro D, Mancin S |
332 - 340 |
Numerical investigation of two-dimensional heat transfer of an absorbing plate of a flat-plate solar collector using dual-reciprocity method based on boundary element Mortazavinejad SM, Mozafarifard M |
341 - 359 |
Determining combined effects of solar radiation and panel junction temperature on all model-parameters to forecast peak power and photovoltaic yield of solar panel under non-standard conditions Zaimi M, El Achouby H, Ibral A, Assaid EM |
360 - 370 |
Thermal efficiency of a flat-plate solar collector filled with Pentaethylene Glycol-Treated Graphene Nanoplatelets: An experimental analysis Alawi OA, Kamar HM, Mallah AR, Kazi SN, Sidik NAC |
371 - 381 |
The impact of temporal smoothing on the accuracy of separation models Blaga R |
382 - 399 |
The engineering design of a high-performance parabolic trough collector using lumber for the support structure Peralta NR, Gleckman P |
400 - 409 |
Oxygen non-stoichiometry in TiO2 and ZnO nano rods: Effect on the photovoltaic properties of dye and Sb2S3 sensitized solar cells Sharma V, Das TK, Ilaiyaraja P, Sudakar C |
410 - 419 |
A three-equation thermocline thermal energy storage model for bidisperse packed beds Odenthal C, Klasing F, Bauer T |
420 - 426 |
A facile synthesis of ruthenium/reduced graphene oxide nanocomposite for effective electrochemical applications Dao VD, Hoa ND, Vu NH, Quang DV, Van Hieu N, Dung TTN, Viet NX, Hung CM, Choi HS |
427 - 434 |
Photocharged molybdenum-doped BiVO4 photoanodes for simultaneous enhancements in charge transport and surface passivation Tayebi M, Tayyebi A, Lee BK |
435 - 448 |
Corrosion of alloys in high temperature molten-salt heat transfer fluids with air as the cover gas Liu TL, Xu XH, Liu WR, Zhuang XR |
449 - 458 |
A circadian design assist tool to evaluate daylight access in buildings for human biological lighting needs Konis K |
459 - 467 |
TiO2 hierarchical nanowire-P25 particulate composite photoanodes in combination with N-doped mesoporous carbon/Ti counter electrodes for high performance quantum dot-sensitized solar cells Song H, Pan ZX, Rao HS, Zhong XH |
468 - 480 |
An assessment of the proportional-integral control tuning rules applied to Photovoltaic Irrigation Systems based on Standard Frequency Converters Fernandez-Ramos J, Narvarte L, Lopez-Soria R, Almeida RH, Carrelo IB |
481 - 496 |
Multi-objective optimization of energy performance of a building considering different configurations and types of PCM Markarian E, Fazelpour F |
497 - 504 |
Parametric synergy of passive design elements in cold-cloudy climate zones of north-east India Tungnung K |
505 - 517 |
Design and performance simulation of a novel hybrid PV/T-air dual source heat pump system based on a three-fluid heat exchanger Zhang PL, Rong XY, Yang XR, Zhang DL |
518 - 529 |
Solar photocatalytic disinfection using ink-jet printed composite TiO2/SiO2 thin films on flexible substrate: Applicability to drinking and marine water Levchuk I, Homola T, Moreno-Andres J, Rueda-Marquez JJ, Dzik P, Morinigo MA, Sillanpaa M, Manzano MA, Vahala R |
530 - 539 |
Technical-economic analysis of the insertion of PV power into a wind-solar hybrid system Carvalho DB, Guardia EC, Lima JWM |
540 - 548 |
Preparation and testing of thermochromic coatings for buildings Zhang YX, Zhai XQ |
549 - 565 |
Pathway towards achieving 100% renewable electricity by 2050 for South Africa Oyewo AS, Aghahosseini A, Ram M, Lohrmann A, Breyer C |
566 - 573 |
Synthesize non-fullerene acceptors of five fused-ring by modifying side chain Li J, Feng LL, Cai FF, Zhang ZZ, Wei QY, Peng HJ, Zou YP |
574 - 584 |
Evaluation of anti-soiling coatings for CSP reflectors under realistic outdoor conditions Wette J, Sutter F, Fernandez-Garcia A |
585 - 595 |
Experimental study on the thermal performance of capric acid-myristyl alcohol/expanded perlite composite phase change materials for thermal energy storage Liu CZ, Luo CY, Xu TT, Lv PZ, Rao ZH |
596 - 622 |
Comprehensive review on effect of dust on solar photovoltaic system and mitigation techniques Gupta V, Sharma M, Pachauri RK, Babu KND |
623 - 628 |
Theoretical analysis of solar thermophotovoltaic energy conversion with selective metafilm and cavity reflector Ni Q, McBurney R, Alshehri H, Wang LP |
629 - 636 |
Rapid large-grain (> 100 mu m) formation of organic-inorganic perovskite thin films via shear deposition for photovoltaic application Choe J, Song J, Lee D, Byun HR, Jeong MS, Chung CH, Hong KH, Kim J |
637 - 646 |
Damage analysis of 601 nickel superalloy in eutectic Na2CO3/NaCl molten salt under isothermal and thermal cycling conditions Bell S, Lippiatt K, Steinberg T, Will G |
647 - 653 |
Improvement of planar perovskite solar cells by using solution processed SnO2/CdS as electron transport layer Mohamadkhani F, Javadpour S, Taghavinia N |
654 - 662 |
Unsymmetrically pyrazole-3-carboxylic acid substituted phthalocyanine-based photoanodes for use in water splitting photoelectrochemical and dye-sensitized solar cells Yildiz B, Guzel E, Akyuz D, Arslan BS, Koca A, Sener MK |
663 - 671 |
An investigation on surface modified TiO2 incorporated with graphene oxide for dye-sensitized solar cell Chong SW, Lai CW, Juan JC, Leo BF |
672 - 685 |
Methodology of Koppen-Geiger-Photovoltaic climate classification and implications to worldwide mapping of PV system performance Ascencio-Vasquez J, Brecl K, Topic M |
686 - 696 |
Evaluating a concentrating solar power plant as an extended-duration peaking resource Yagi K, Sioshansi R, Denholm P |
697 - 706 |
Aplanats and analytic modeling of their optical properties for linear solar concentrators with tubular receivers Gomes ETA, Fraidenraich N, Vilela OC, Oliveira CAA, Gordon JM |
707 - 718 |
Reflective optics for redirecting convergent radiative beams in concentrating solar applications Li LF, Wang B, Bader R, Zapata J, Lipinski W |