This study investigated the electrochemical behavior of chromium nano-carbide cermet coating applied on Ti-6Al-4V and Co-Cr-Mo alloys for potential application as wear and corrosion resistant bearing surfaces. The cermet coating consisted of a highly heterogeneous combination of carbides embedded in a metal matrix. The main factors studied were the effect of substrate (Ti-6Al-4V vs. Co-Cr-Mo), solution conditions (physiological vs. 1 M H2O2 of pH 2). time of immersion (1 vs. 24 h) and post coating treatments (passivation and gamma sterilization). The coatings were produced with high velocity oxygen fuel (HVOF) thermal spray technique at atmospheric conditions to a thickness of 250 mu m then ground and polished to a finished thickness of 100 mu m and gamma sterilized. Native Ti-6Al-4V and Co-Cr-Mo alloys were used as controls. The corrosion behavior was evaluated using potentiodynamic polarization, mechanical abrasion and electrochemical impedance spectroscopy under physiologically representative test solution conditions (phosphate buffered saline, pH 7.4, 37 degrees C) as well as harsh corrosion environments (pH similar to 2, 1 M H2O2, T = 65 degrees C). Severe environmental conditions were used to assess how susceptible coatings are to conditions that derive from possible crevice-like environments, and the presence of inflammatory species like H2O2. SEM analysis was performed on the coating surface and cross-section. The results show that the corrosion current values of the coatings (0.4-4 mu A/cm(2)) were in a range similar to Co-Cr-Mo alloy. The heterogeneous microstructure of the coating influenced the corrosion performance. It was observed that the coating impedances for all groups decreased significantly in aggressive environments compared with neutral and also dropped over exposure time. The low frequency impedances of coatings were lower than controls. Among the coated samples, passivated nanocarbide coating on Co-Cr-Mo alloy displayed the least corrosion resistance. However, all the coated materials demonstrated higher corrosion resistance to mechanical abrasion compared to the native alloys. (C) 2011 Elsevier Ltd. All rights reserved.